Snow Performance Stage II Boost Cooler Forced Induction Water Injection Kit

Unlock 50-70+HP on your boosted vehicle while decreasing your air temps by up to 100 degrees! Increase your pump gas octane by 25 points and make more power efficiently with a cooler running motor! The Snow Performance Stage 2 Boost Cooler® water-methanol injection kit is available for all forced induction applications (supercharged/turbocharged) and uses a progressive controller with built in manifold absolute pressure (MAP) sensor that proportionally injects more or less water-methanol according to boost pressure. Start and full points are adjustable for engagement and delivery curve to match what the engine requires. Proportionally injecting according to boost pressure gives an accurate delivery of water-methanol and allows cooling and performance improvements over a wide range for improved drivability. Recommended for all gas forced induction vehicles using a turbo or centrifugal supercharger. Comes with adjustable progressive VC-20 engine mount controller and easy to install quick-connect fittings. Stage 2 Boost Cooler™ Forced Induction Progressive Engine Mount Water-Methanol Injection Kit (Red High Temp Nylon Tubing, Quick-Connect Fittings)

• Snow Performance OEM-Approved Extreme Environment 300 PSI UHO Water Methanol Pump
• 100% Methanol Resistant (Stainless Steel, Nickel Plating, Hard Anodizing, EPDM)
• Recommended For Street Driven Turbo and Centrifugal Supercharger Applications
• Snow Performance Running "S" Engraved Low Profile High Flow Check Valve
• Snow Performance Running "S" Engraved Low Profile Nozzle Holder
• Adjustable Progressive Water-Methanol Engagement & Monitoring
• Snow Performance ACU-SEAL Water-Methanol Compression Fittings
• Snow Performance Hyper-Sonic Water Methanol Nozzle
• Supports 1,000+ HP
• U.S.A. Made