Snow Performance Stage 3.5 Boost Cooler Direct Injected VC-100 Progressive Water Inj Kit (w/o Tank)

The Snow Performance Stage 3.5 Boost Cooler® brings true 2D mapped water-methanol injection delivery to your DI (direct fuel injected) and forced induction (turbocharged/supercharged) vehicle. The Stage 3.5 creates a 2D injection map based off boost and fuel pressure sensor input to deliver an extremely accurate amount of water-methanol when the engine needs it most. Bringing fuel pressure into the mix allows the injection curve to be extended past specific boost points for greater range/control. None invasive, the Stage 3.5 Boost Cooler® controller is designed to mount like a traditional gauge pod. Proven to reduce the air inlet temperature by up to 100 degrees and increase octane by 25 points for maximum HP and cooling . Comes with adjustable Stage 3.5 water-meth controller (VC-100), 4AN fittings, and stainless steel braided line to mount pump/tank in engine bay of vehicle. For trunk mount options see Part# SNO-40014-BRD, SNO-40012-BRD. Stage 3.5 Boost Cooler Direct Injected VC-100 Progressive Water-Methanol Injection Kit - No Tank (Red High Temp Nylon, Quick-Connect Fittings) NOT FOR TRUNK MOUNTING, SOLENOID(SNO-40060) AND LONGER FEEDLINE IS NEEDED IF MOUNTING IN THE TRUNK

• Snow Performance OEM Approved Extreme Environment 300 PSI UHO Water Methanol Pump
• 100% Methanol Resistant (Stainless Steel, Nickel Plating, Hard Anodizing, EPDM)
• Recommended For Street Driven Turbo and Centrifugal Supercharger Applications
• Snow Performance ACU-SEAL Water Methanol Compression Fittings
• Adjustable Progressive Water Methanol Engagement & Monitoring
• Snow Performance Hyper-Sonic Water Methanol Nozzle
• Snow Performance Low Profile High Flow Check Valve
• Snow Performance Low Profile Nozzle Holder
• Digital Boost Reading (1-100 PSI)
• Supports 1,000+ HP
• U.S.A. Made